When setting up an Stamps Carrier baseline account to ship through USPS, you will have to:


NOTE: This article describes how to set up the Carrier baseline account.
If the Carrier baseline account has already been set up and you intend to add a new Billing Account, refer to: How to add and set up a USPS (Stamps) Billing Account [Step-by-Step guide]




CARRIER SECTION

1. Access Maintenance and select Carriers


2. Click the Carrier for which you'll add the account to from the list


3. Click the Accounts tab


4. Click Add Account



5. In General Options set:

  1. Name -> USPS - [Account number] (e.g. USPS - 500000)
  2. Usage mode -> Production
  3. Status -> Active
  4. Label mode -> AZPL (NOT REGULAR ZPL)
  5. SCAC -> Carrier/SCAC code you're using in the WMS 


WARNING: To avoid getting charged by carrier estimations, you can enable Dimensions Required, which will require dimensions for every shipment and send an error message if these are missing. 




6. In Carrier Options set and Save:


REQUIRED

  1. Username and Password -> Stamps Username and Password
  2. Sender address info -> Warehouse induction address

OPTIONAL


  1. Pick Up Open, Close and Ready Hours time -> Warehouse pick up open and pick up close time, as well as Ready Hours (how many hours will it take you to be ready from your open time)
  2. Contact information -> Contact First and Last name


 


Once ready, proceed to setting up the Billing Account as described in:

How to add and set up a USPS (Stamps) Billing Account [Step-by-Step guide]