When setting up an MH10 or Custom Label, the Techdinamics staff in charge of developing and designing it will leave a profile set up and ready in your portal, so no steps are required for the first setup.
Nevertheless, if you need to replicate the setup on a different portal (techSHIP MultiSite only), you can clone the setup from the original portal to any other as described below:
NOTE: This article describes how to set up the Carrier baseline account.If the Carrier baseline account has already been set up and you intend to add a new Billing Account, refer to: How to add and set up a Standalone MH10 label Account [Step-by-Step guide]
If you intend to print the MH10 or Custom Label together with a Carrier Shipping Label (e.g. UPS, FedEx, etc.) refer to the following article instead: How to print Regular Labels and MH10 Labels at the same time [Step-by-Step guide]
CARRIER SECTION
1. Access Maintenance and select Carriers
2. Click the MH10 or Custom Label profile you'll clone the account from
3. Click the Accounts tab
4. Click Copy
5. Select the Target Portal
6. Select the Target Carrier (where the account will be cloned under)
NOTE: To have a Carrier display in the Target Carrier dropdown, it must be set up in the Target Portal. If not showing properly, reach Sales and techSHIP support.7. Press Save to confirm
Once ready, proceed to setting up the Billing Account as described in: How to add and set up a Standalone MH10 label Account [Step-by-Step guide]